PAX EGD-250

A: Guide Bearings are Widely Spaced and the Unit is Driven at Bearings, which resist off-center loading & maximize bearing life. B: Elliptical Gear Drive in Sealed Oil Bath C: Electric Motor EGD-250-48 T- Slot Mounting Brackets: Brackets are bolted to the conveyor base plate, are slid into the bolster T-slots, and large set screws are utilized to fasten the brackets in place. Once in place, bolts at the bottom of the bracket are extended outward until they push snugly against the bottom of the bolster, to increase the bracket’s support and reduce its vibration. Standard brackets are based on a bolster that is a minimum of 6” thick with standard 1” T-Slots and the brackets will mount into two separate T-slots that must be spaced 48” apart. Brackets are not available for the EGD-250-72. EGD-250-48 T- Slot Mounting Brackets EGD-250-48 Vertical Face Mounting Brackets: Brackets are bolted to the conveyor base plate and are arranged to be bolted to a vertical surface (such as the face of a bolster plate). Brackets are not available for the EGD-250-72. Option of Utilizing an Extruded Aluminum Cross Bar in Place of Pax’s Standard Cross Bar: For customers who have standardized extruded aluminum type cross bars, the EGD-250 conveyors can be arranged for an extruded aluminum bar. The standard arrangement is for a 1.5” x 4.5” extrusion that has a 1.5” spacing between T-slots and a T-slot opening of 0.32”.