PAX EGD-125

Optional, Quick Release Arm Arrangement: To provide increased access to the press, this quick-release option allows the operator to simply lift the arm, (crossbar), off of the unit and to re-install the arm by simply placing it back on top of the unit. No tools are required to remove or replace the arm. A: Alignment components slide into notches on angle brackets to assure the arm is correctly located on the unit. B: Magnets hold arm between brackets C: Angle brackets prevent the arm from moving Front to Back EGD-125: T- Slot Type Mounting Brackets (PN: EGD-125-6099-0): Brackets mount to the bottom of the EGD unit and can be fastened inside of T-slot. Standard brackets are based on a minimum bolster thickness of 4”, a distance of 23.62” to 24” between the mounting T-slots, and standard 1” T-Slots (brackets have a 1.75” wide x 0.75” thick bar that needs to be clamped into the bottom portion of the T-slot), and the edge of the bolster must be less than 6” from the end of the press bed. EGD-125: T- Slot Type Mounting Brackets EGD-125: Shelf Type Bracket Model (PN: EGD-125-6098-0): The shelf-type mounting bracket can be bolted to a vertical surface such as the press bed. After the bracket is properly attached, the EGD conveyor is bolted to the top of this bracket. EGD-125: Vertical Face Mount Brackets: These brackets are designed to bolt to the bottom of the EGD unit and to a vertical surface. The bracket design is based on the following: EGD-125: Shelf Type Bracket Model Each of the two brackets has two 0.53” diameter clearance holes for mounting bolts. These holes are located 3.25” apart. When brackets are mounted to the EGD conveyor, the total width of assembly is 26.7” and the distance between the mounting holes on the two brackets is 24.7”. Minimum height of mounting surface (bolster thickness) of 4.25”. Brackets will be painted black. EGD-125: Floor Mount Brackets: These brackets are designed to be bolted to the bottom of the EGD unit and then bolted to the floor. The width of the brackets is 28”. The diameter of clearance holes for floor anchors is 0.44”. The Center distance between the above clearance holes is 26” Distance from floor to bottom of the tray, (when the tray is parallel to the floor and does not have wear pads attached), is 9.9”. EGD-125 Rolling Floor Stand: Each stand (with the EGD unit attached) can be rolled up to the press and then fastened to the press’ T-slots. Contact Pax for further information. EGD-125 Rolling Floor Stand EGD-125 Adapter Plate for Extruded Aluminum Cross Bar: For customers who have standardized extruded aluminum type cross bars, Pax can provide the EGD unit with an adapter plate designed for an extruded aluminum bar. This plate has two keys that are designed to fit into one of the extruded aluminum bar’s t-slots and it has four 0.32” clearance holes. Standard adapter plate is designed for a 1.5” x 3” extrusion that has a 1.5” spacing between T-slots and a T-slot opening of 0.32”.